<legend id="02Uc4"></legend>
Liquid silica gel is divided into glue a and glue B. the ratio of glue a to glue B is 1:1 controlled by a quantitative device, and then it is fully mixed by static mixer and injected into the injectio
Considering that the power engineering products users must directly let the feeder quantitative output according to the mold cavity capacity, and the adaptability of the injection process must be considered in the whole process of injection, and the injection rate of the liquid silica gel feeder mus..
The material supplier provides a low-viscosity, high-temperature vulcanized dual-group silicon material to be used, packed in 20 or 200KG containers A and B. Using a two-component mixing and batching
1. When the liquid silicone bracelet is made of carbon black, the outer surface of the silicone should be thicker to avoid the illusion of shiny surfa..
Liquid silicone machine in the use of the situation, it is necessary to timely check its lead-in head is good, if the lead-in head causes common problems, then the introduction of the whole process wi
Liquid silicone injection machine can be used to make infant products, such as bottle nipple, glass bottle, bottle nipple, teeth, spoon, bowl and other infant feeding appliances. It can also be used t
The intelligent liquid silica gel feeding system is adopted in the liquid silica gel feeding machine instead of manual operation, which greatly saves the labor cost. The liquid silica gel feeder has t
The liquid silica gel injection molding machine has the function of slow mold calibration, which makes the mold calibration more accurate and safe. It is a new type of multi-functional mold, which is
The liquid silica gel machine can directly input the injection quantity required by different commodity molds on the man-machine interface. The feeding system counts the output while feeding. When the
Considering that the power engineering products users must directly let the feeder quantitative output according to the mold cavity capacity, and the adaptability of the injection process must be cons
<legend id="02Uc4"></legend>